Group 10 Equipping/Maintenance Page 342
Release R2.0 LEIBINGER JET3
For correct handling the LEIBINGER re-filling system allows an odor- and splash free
refilling of the consumables.
The reservoir tanks should be not overfilled, that means a re-filling
should be only carried out if a certain message has been generated by
the printer!
(Example: Re-filling of solvent)
Risk of fire and injury! Absolutely observe!
Before filling the device with the consumables, measures for the
electrostatic discharge have to be made!
Highly flammable! Burning gases and liquids may cause severe
burns. Keep sources of ignition away from the printer!
Always statically discharge the printer and yourself before filling
the reservoirs! Simply touch the housing of the printer to discharge
the equipment and stand on a grounded surface wearing ESD shoes
during filling!
Protective equipment is necessary! Read the safety data sheets and
the personal protective equipment rules and regulations!
The sealing of the refill bottle should be not opened!
Open the cap (2) of the re-filling unit (1).
Open the screw cap of the solvent tank (4) and of the re-filling bottle (5).
Put the re-filling bottle on the solvent tank. The seal of the bottle will be breached
and the closing valve of the tank will open automatically and the reservoir tank is
filled up.
Wait until the re-filling bottle is completely empty.
To Next Page
Loading...
