Group 11 Taking out of operation/Dismantling Page 350
Release R2.0 LEIBINGER JET3
11. Taking out of operation/Dismantling
11.1 Taking out of operation
The ink and solvent which still remains in the high performance printer have to be
removed. For this a special draining routine is available.
You will find further information regarding the procedure of draining in the
chapter Draining routine!
Dangerous material in the machine!
Protective equipment is necessary! Read the safety data sheets and the
personal protective equipment rules and regulations!
Now the high performance printer has to be turned off and disconnected from the mains
supply. Further more you have to disconnect possible connected additional devices. You
will find the capabilities of connecting on the back side of the device. You have to follow
the instructions of the serveral devices!
Finally you have to cleanse the device of dirt, ink rests etc. as described in the chapter
Cleaning.
11.2 Dismantling/Disposal
The LEIBINGER JET3 has been developed and built with materials that ensure problem-
free dismantling and disposal. When dismantling, the information in the chapter Taking
out of operation as well as the respective country specific disposal regulations (e.g. for
inks and solvents) must be taken into consideration
To Next Page
Loading...
