Group 5 Transport/Start up Page 38
Release R2.0 LEIBINGER JET3
For adaption to the production line several works have to be carried out and operating
parameters have to be set before start of operation.
The device does not have a mains switch and should be only connected
to an easy accessible socket close to the installation location!
The LEIBINGER JET3 should be connected to AC voltage 100 - 240 V AC, 50 – 60
Hz with an appropriate plug. The socket should be provided with a clear designation
(e.g.: JET3).
After connecting to the mains power supply the initialization of the device will be
carried out automatically. After this process the JET3 is ready for operation.
You will find further information regarding the initialization in the
chapter Initialization of device!
5.3.2 Grounding (Potential equalization)
Grounding (Potential equalization)!
In case of a non existing grounding or that the grounding of the
printer is not carried out properly, this could cause serious injury or
death and it can also cause malfunctions or damages at the printer!
These dangers or demolitions can happen for example because of
electrostatic discharge (ESD) or potential difference!
Especially for countries without existing protected earth connection, there is a special
grounding point located at the side of the printer.
This threaded socket must be connected to ground if there is no ground pin in the
mains socket/plug.
To Next Page
Loading...
