Leibinger Jet 3 - Numeric Keypad Usage

Group 6 Operation – Elements and procedures Page 70
Release R2.0 LEIBINGER JET3
 Device status (traffic light) (9): The status traffic light visualizes the current condition
of the JET3.
Figure 20
Status traffic light
1 – red LED
2 –yellow LED
3 – green LED
Display
Device status
Causation/Comment
all LEDs off
No errors or warnings are
pending, but the LJ3 is not
ready to change to the print
mode.
e.g.: Nozzle is closed, head cover
is open, etc.
red LED on
An error is pending which
requires an immediate
interven-tion of the operator
to get the print readiness or to
continue an active print
process.
e.g.: Phasing error, PrintGo-error,
HV-error, etc.
yellow LED on
An intervention of the
operator is required in the
foreseeable future because an
warning is pending.
If the JET3 is in the print
mode, the print process will
be continued.
z.B.: Refill, Leakage, etc.
If the message is acknowledged
without changing the condition
(e.g. no refill has been carried out)
the message will appear again
after one minute.
green LED on
The printer signalizes the
readiness to print or that it
can be switched to the active
print mode.
The button <Print stop> is
illuminated.
 Button <Off> (10): With this button you can switch off the device.
INFORMATION
You will find further information also in the chapter Switch off device!
1
2
3