7/8
To connect to the Leica BLK360 using a LAN connection, install the latest available apps of Cyclone
Data Manager respectively Leica Cyclone Register 360/ Cyclone Register 360 BLK Edition.
Older version do not support the LAN cable feature.
1.4 LAN upgrade kit for Leica BLK360
Leica BLK360 devices with a serial number lower than 3507273 can be upgraded to support the LAN
feature.
Service news will be available with details on the upgrade process.
2. Issue fixed in v2.1.0
2.1 Memory
The version 2.0.1 fixes an issue, where the user was not informed when the internal memory was full.
This led in some cases to a situation where a scan could not be started.
Only a generic error message was shown in Leica Cyclone Field360 that wasn`t telling the root cause of
the problem – a full internal memory of the Leica BLK360.
If the push button was used to start a scan with a full internal memory the LED stayed green, but the
scan didn`t start.
This issues is fixed with this release.
3. Important
Whenever the Leica BLK360 is not shut down properly, this could be due to
• Taking out the battery before shutting down the device using the power button, or
• In rare cases the sensor shuts down unexpectedly
this will be indicated by a warning state (orange LED ring) at the next start of the device.
A press on the power button will reset the warning state and the Leica BLK360 will again be fully
operational.
Note: It is recommended to perform a re-scan of the last job to ensure the data are complete!
A restart of the device is not required!
To Next Page
Loading...
Need help?
General
