60
The displays
THE DISPLAYS
IN THE VIEWFINDER
1 2 3 5 6 97 8 1210 11
6 12
4
1 Horizon
(Tilting about the longitudinal axis/inclination about the transverse axis;
values apply as examples for inclination in clockwise direction; other
directions are shown analogously)
–
max. ±0.5°
–
0.5-2.5°
–
2.5-5°
–
5-10°
–
flashing ≥10°
2 Shutter speed/exposure time
– Manually set value for
and , automatically controlled value for
and ; display in half steps, or
–
(high) or (low) for overexposure or underexposure in the
automatic exposure modes
, , and by flash light, or for
values below the metering range.
–
B setting for long exposures
–
Warning message for full memory card(s)
3 Exposure operating mode
–
Automatic program
–
Aperture priority
–
Shutter speed priority
–
Manual setting of shutter speed and aperture
4 Aperture
Manually set value for
and , automatically controlled value for
and
; display in half steps
5 Flash display
Lit Ready
Flashing Flash charging, not ready
6 Light scale
(Marks: each
1
⁄2
EV step, last marks/figures flash at ≤ -3EV/≥ +3EV )
to indicate
– Manual exposure compensation,
– Deviation of the current metering from the stored exposure setting
(with metered value storage in the automatic exposure modes
,
, )
– Exposure compensation
7 Flash display
Lit = Shutter speed set ≥ sync speed
8 Focus displays
–
Appears only in manual mode or in the case of manual override
of the AF: Lights up continuously if the distance is set too far
–
In manual mode: Lights up continuously with correct setting
– With
AFs: Lights up continuously with correct setting, flashes
if correct setting is not possible,
– With
AFc: Lights up continuously with correct setting, goes
out if focusing is restarted
–
Appears only in manual mode or in the case of manual override
of the AF: Lights up continuously if the distance is set too short
9 Exposure compensation / flash exposure compensation set
10 Exposure metering method
–
Multi-field metering
–
Center weighted metering
–
Spot metering
11 Picture counter
–
Total remaining number of pictures
–
External storage
–
(flashing with 2 Hz) = Memory card full
–
(flashing with 2 Hz) = No memory card inserted
–
Maximum number for picture series
–
Error message
12 ISO sensitivity
–
For manual setting
–
For automatic setting
–
HI 1
(ISO3200) /
HI 2
(ISO6400) /
HI 3
(ISO12500)=
Currently set sensitivity
Note:
The viewfinder LCD is always lit when the camera is switched on. The
brightness of this lighting is automatically adapted to the ambient bright-
ness for optimum legibility.
Inhalt_EN.indd 60 12.10.2015 09:34:28
To Next Page
Loading...
