Leigh FMT PRO - Jig Operation Concept

16
Chapter 3 Frame Mortise & Tenon Jig User Guide
THE FMT PRO JIG
3-29 If the finger-hole is not accessible from below, use your fin-
gernail or a small non-metallic pry to lift the Guide up
➂
.
■
3
3-30 The selected guide is placed into the guide recess and the
matching bit fitted to the router.
1
2
3-31 The centers of a mortise and tenon are marked with a cross.
90˚
3-32 Tenon workpieces are usually clamped vertically
➀
. Mortise
workpieces are always clamped horizontally
➁
.
1
2
3-33 The jig table is centered over the marked workpiece with
the extended sight
➀
.
1
1
Jig Operation Concept