Leigh FMT PRO - Page 4

iv
Frame Mortise & Tenon Jig User Guide
Square Tenons
Square tenons are often used
for replicating period furniture.
Item 670900
Visit www.leighjigs.com for more details
SPECIALTY GUIDES
Y-Axis Mortise
In instances when mortises
need to be routed at 90º to the
clamp plate, this guide does
the trick.
Item 6701YAM
Extra Clamps Save Time
Leigh Surface clamps are identical to FMT Pro clamps. Save time when
switching between mortise and tenon boards. Bonus! This tough,
versatile cam-action clamp can also be mounted on any flat surface, on
any angle or on a table saw. You can never have too many clamps.
Item SHDC1 Surface mount
(one clamp)
Add Leigh Accessories to make your jig even more versatile.
Louver Doors
Make beautiful
louver doors with
these guides and bit.
Joint Guides
Three optional guide sets
are available increasing the
number of joint sizes you
can make to 68! 16 op
-
tional guides in 1/4", 3/8"
Accessory Kit for Savings Combine an optional
guide set and boxed inch bit set for the best savings.
Includes an 8-piece boxed inch bit set and 16 optional
guides in 1/4", 3/8" and 1/2" (6, 10 and 12mm) sizes for
a complete set.
Item ACMT or ACMTC
Router Bits
8-piece set in HSS or Solid
Carbide opens up your
possibilities for joint sizes.
Item 162-180 or 162-180C
Optional Guides, Bits and Accessory Kit
for Great Savings
and 1/2" (6, 10 and 12mm) sizes, make a complete set.
Each guide can be purchased individually or as a set for
better value. Buy all three or as part of the accessory kit
below for even greater savings.
Item 6720 or 6820
Use on jigs and fixtures
Routing tenons with mortise board clamps in place
Routing mortises with tenon board clamps in place Use vertically on bench
1/8" to 3" capacity
1/4" HSS Louver
Guide Bit, 1/2" shank
Item 168-500
L/R matching pair
Item 6701LGP