LEKATO WS-70 - Device Debugging and Multi-Receiver Setup; Configuring Multiple Receivers

Device debugging
— AWS-70 transmitter can be used with multiple WS-70 receivers.
For example ‘There are four effects on a stage, you can use one WS-70 transmitter and four WS-70 receivers
Connect and performances at the same time!
Device debugging:
After turn off all the similar wireless system, use thin iron wire to long press the code button and release the button
until the red light flashing on four receivers. Use thin iron wire to long press the cote button of one transmitter,
release the button when the red! light flashing on the transmitter and all the receivers. It will cost 20 seconds.
When the green light of transmitter and receivers is always on, four receivers can receive signal from one
transmitter at the same time. One-to-many functions can be realized. All code debugging time should be
completed within 20 seconds.
Receiver 2
Receiver 3 Receiver 4