2524 Amsterdam+Assembly & Maintenance Guide
01. Aligning
the brakes
Lift the wheel o the ground and give it a spin. It
should spin freely and not make any noise. If you hear
a metallic rubbing sound, then the brakes will need
adjusting.
To do this, you’ll need to use the 5mm allen key. With
the bike upside down, adjust the caliper. You will
need to slightly loosen the two 5mm allen key bolts
(found on the top of the caliper), so that you can
gently move the caliper horizontally, allowing the disc
rotor to move freely between the brake pads.
To Next Page
Loading...
