Pag. 12
English
BACKFLUSHING:
It is recommended to perform this cleaning at least once a week and / or at least every 100 brewed coffees.
The following instructions apply to all types of groups fitted to all the LELIT coffee machines.
Material needed:
Blind filter (21)
Brush (code PLA9101)
Detergent powder for coffee machine (code PLA9201)
Group cleaning. Follow these steps:
1. Place the blind filter (21) in the filterholder
2. Add 1 single-dose bag of detergent powder (3,5 grams) in the blind filter
3. Insert the filterholder into the brewing group
4. Switch the coffee switch on for about 10 seconds
5. Stop the coffee brewing and wait for 10 seconds
6. Repeat this operation 5 times without removing the filterholder
7. Remove the filterholder, switch the coffee switch on again and rinse the filterholder under hot water that will
be dispensed from the group. Turn the switch off
8. Clean the brewing group and the filter first with the brush and then with a damp cloth in order to remove all
coffee residues
9. Insert the filterholder into the brewing group again and repeat points 4-5-6 without detergent powder
10. Throw away the first coffee you’ll brew
Cleaning of the accessories through immersion. Follow these steps:
1. Place the filters and filterholder in a jug with the filterholder handle upwards
2. Pour 2 single-dose bags of detergent powder in the jug (7 grams)
3. Pour 1 liter of hot water in the jug until the metallic part of the filterholder is completely immerged
4. Wait at least 15 minutes
5. Remove the immerged parts and rinse them with plenty of warm tap water
6. Throw away the first coffee you’ll brew
MACHINE DESCALING
Use of the machine creates a natural formation of limescale, over a time period depending on how frequently the
machine is used and on the hardness of the water.
Limescale deposits can obstruct the tubes and decrease the brewing temperature, altering the quality of the coffee
and reducing the lifetime of your machine.
To avoid the formation of limescale, which can also deposit in the internal circuits, we recommend the use of our
LELIT resin filter (code PLA930M - not included) to soften the water. Please insert the water softener filter in the tank
following the instructions on the packaging. The filter purifies the water from the calcium and magnesium salts which
are deposited to form limescale and affect the taste of your coffee. Remember that the filter loses its efficacy after a
certain amount of water treated, so replace it periodically. Instructions for the use and replacement of the filter are
given on the box.
To avoid any possibility of damaging of the machine’s components, ADD ONLY NATURAL DESCALING PRODUCTS
INTO THE WATER TANK.
TECNICAL DATA:
Voltage: 220-240V 50Hz; Power: 1050W
Heating time: ca. 3 min.; Pump pressure: 15 bar
Water tank: 2,7 litres
Dimensions (HxLxD): 34*23*27 cm
Weight: 9 kg
To be operated with ground coffee and coffee pods
PL41EM-120: 120V - 60Hz; power 1050W
PL41EM-AS 220V 60Hz; power 950W
To Next Page
Loading...
