Pag. 11
English
36. Insert the filterholder (8) into the brewing group (5), turn it from left to right with force, then put the cup on the
removable water drip tray grate (7).
37. Press the coffee/hot water switch (13). The pressure value on the manometer (17) should reach the green zone
during the extraction.
38. Once you get the coffee desired quantity, push the coffee/hot water switch (13) again.
39. Remove the filterholder (8) and throw the used pod away.
Steam:
40. Check that the water tank (1) has been filled in with water by looking at the water level indicator (20).
41. Press the on/off switch (11): the LED light “machine on” (14) will turn on. Do this operation only if the machine
is off. If it’s on pass to the following point.
42. Press the steam switch (12).
43. As soon as the indicator light machine ready (3) turns on, the machine is ready for use.
44. Open the steam/hot water knob (4). First some water will come out of the wand, then steam.
45. Put the cup with the desired infusion under the steam /hot water wand (6) and turn the knob completely.
46. When the drink has been suitably frothed, close the steam/hot water knob (4) and press the steam switch (12)
again.
47. IMPORTANT: after you have frothed your milk, open the steam/hot water knob (4) again and press the steam
switch (12) and the coffee/hot water switch (13) again. When some water flows out of the steam wand (6),
close the steam/hot water knob (4) again and press the steam switch (12) and the coffee/hot water switch
(13) again at the same time. Clean the steam/hot water wand (6) carefully.
Hot water:
48. Check that the water tank (1) has been filled in with water by looking at the water level indicator (20).
49. Press the on/off switch (11): the LED light “machine on” (14) will turn on. Do this operation only if the machine
is off. If it’s on pass to the following point.
50. As soon as the indicator light machine ready (3) turns on, the machine is ready for use.
51. Before preparing your drinks, it is advisable to open the steam/hot water knob (4) and press the steam switch
(12) and the coffee/hot water switch (13). You will have immediately water coming out of the steam/hot water
wand (6). Dispense water into the drip tray for 5 seconds. After that press the coffee/hot water switch (12) and
the steam switch (12), then close the steam/hot water knob (4).
52. Place an empty jug / cup under the steam/hot water wand, open the steam/hot water knob (4) again.
53. Press the steam switch (12) and the hot coffee/hot water switch (13). Hot water will come out of the steam/hot
water wand (6) immediately.
54. Once you have got the desired quantity of water, repress the steam switch (12) and the coffee/hot water switch
(13) again and close the steam/water knob (4).
55. After obtaining hot water from the steam/hot water wand (6), make sure that there is still water in the tank (1).
USEFUL TIPS:
- The single cup filter (9), the two-cup filter (10), the pod filter (18) and the blind filter (21) do not need to be
washed after each use but check that the holes are not clogged.
- For best results, we suggest warming the cups up on the cup warmer (2) which works only when the machine
is on.
CLEANING AND MAINTENANCE
Cleaning and maintenance of the machine are essential for the quality of the coffee and the durability of the
appliance.
Cleaning
The machine must be cleaned at least once a week.
Before starting, remove the plug from the electrical outlet and allow the machine to cool.
Use a soft cloth, preferably microfiber, like the LELIT cloth (code PLA9101 - not included), and moisten
it with tap water. Do not use any abrasive detergent and do not immerse the machine in water.
For thorough maintenance, we suggest using the LELIT brush (code PLA9101 - not included), which will help you
clean the shower and the spaces between the gaskets more effectively, removing stains and coffee residues from
even the smallest cracks.
Warm running water can be used to clean the removable parts of the machine. The filters and filterholder should
never be washed in dishwasher.
There is no need to clean the filters after each use, but just to ensure they are not clogged.
However, to ensure the best performance from your machine, it is essential to thoroughly clean the steam wand and
filterholder after each use.
The filterholder should be cleaned to remove the greasy coffee residues that can negatively affect the taste of your
coffee.
Wash the external part of the steam wand with a damp cloth and release a little steam to remove any milk residues
from inside the wand, as these could obstruct the steam output, making it more difficult to froth milk properly.
To Next Page
Loading...
