13
C
Switch on the coffee machine
Caution. Ensure the power supply voltage is the same as that indicated on the
information plate and that the supply system has an adequate circuit breaker.
C.1 Connect one end of the power cord (c) to the socket in the machine and the
other (plug) into the wall socket.
C.2 Turn on the espresso machine by pressing the main on/off switch (2). The dis-
play (12) will show the Lelit logo, the three switches and the gauge will go on for a
short time.
Note. ONLY for the rst time that the machine is switched on, the machine will
start to ll the boiler automatically. During this operation, water will ow from the coee
distribution group for about 40 seconds and the Lelit logo will ash on the LCC display.
C.3 On the LCC display (12) you’ll see the water boiler temperature ashing. This will
grow until the set temperature will be reached.
C.4 Wait until the bar is fully loaded and “Ok” appears on the display. This way the ma-
chine will reach the set temperature.
C.5 After reaching the pre-set temperature, the bar will disappear. The machine will be
ready for use.
D
Checking that the machine is working properly
Coffee
D.1 Insert the lter holder (e) without coffee rmly into the coffee distribution
group (6), so as to align the handle with the padlock symbol on it.
Note. With a new machine, in order to reach this position, it is advisable to moisten
the edge of the lter with water. Aer a short period of use, this position will be reached
regularly without excessive eort.
D.2 Press the coffee switch (3) to dispense about half a litre of water. The display
(12) will show the coffee icon and a countdown from the pre-set time for the
coffee dispensing.
D.3 When you’ve taken about half a litre of water, press the switch (3) to stop dispensing.
Note. This procedure helps lling the hydraulic circuit completely and
rinsing the circuit itself.
To Next Page
Loading...
