Pag. 9
ENGLISH
CAUTION:
✓ Do not leave the machine unattended while the plug is connected to the socket.
✓ For complete safety, before filling the boiler, please disconnect the plug.
✓ While using the machine and 30 minutes afterwards (even with the unit disconnected) the iron plate has very
dangerous temperature – do not touch it.
✓ Clean the appliance body with a wet cloth - please use just water to make it wet - (make sure that the plug
has been disconnected at least 60 minutes before: BURN DANGER)
✓ While ironing use the supplied pad to rest the steam iron.
✓ The machine has a special heating element. Only qualified technician should replace it.
✓ While using the machine, never unscrew or remove the cap (1). Before removing it, make sure that it does
not release steam anymore from the iron.
✓ The safety cap (1) must be replaced with original parts only.
TROUBLESHOOTING:
Steam comes out
from the boiler
It may happen that, while filling
the tank, some water spilled over
the cap and flew inside the boiler
wetting the insulating material
In order to solve the problem, we suggest using the
machine as usual so to dry up the insulating material
through the heat of the machine. In case you still
have this problem after one working hour, please
contact the service centre
The steam iron
leaks steam mixed
with water
While filling the tank you may
have poured too much water into
it.
Remove the excess water from the machine (follow
carefully the instructions to release the steam before
opening the security cap)
The iron plate has to be hot
before the steam passage
Please check that the temperature knob is on the
right position: “cotton
°°°)”
The iron switch might be off
Turn the iron switch on, the red led comes on; wait
for 4 minutes so that the iron plate warms
The boiler switch might be off
Turn the boiler switch on, the red led comes on: wait
for 15 minutes so that the boiler reaches the right
pressure to produce steam.
The water might be finished (the
low water light indicator might be
on)
Fill it to the required level following the instructions
carefully (see point 13).
The ironing board cover might
not be able to absorb the steam
completely
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better. In
case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
The steam iron leaks steam
mixed with water (check by
spraying some steam on a dry
cloth)
See the paragraph: the steam iron leaks steam mixed
with water
The iron leaks dirty
water
Maybe some dirty water might
have gone into the tank and it is
given off from the iron.
Fill the empty tank with 1 litre of water, screw the cap
up, shake it, open the cap and empty the tank.
Repeat the action until the water is clean. We do not
recommend the use of any additive to pour into the
tank. Before ironing again spray some steam on a
cloth until clean steam comes out.
To Next Page
Loading...
