Why is the long end of twine frayed with twine fibres left in the twine holder of my LELY WELGER Accessories?
If the long end of the twine is frayed and twine fibres are left in the twine holder, it might be because: * Spring “f" too highly tensioned: Loosen screw "g". adjust measurement “E".
General| Type | Round baler |
|---|---|
| Bale diameter | 0.9 - 1.8 m |
| Bale Weight | Up to 500 kg |
| Net Wrap System | Yes |
| Twine System | Yes |
General guidelines for safe operation and maintenance of the AP baler or thrower P23.
Key safety practices for operating and maintaining the baler, including personal protective equipment and alertness.
Explanation of meanings for various safety decals, including type, meaning, and spare part numbers.
Identifies safe operator positions and danger zones around the machine during operation.
Safety warning regarding the risk of injury from thrown bales during operation.
Diagnosing and fixing common faults related to twine tying, including knot appearance and twine tension.
Scheduled maintenance tasks based on working hours or time intervals (20, 50, 100, 500 hours).
Step-by-step guide for draining and refilling the transmission oil in the baler.
Instructions for installing, adjusting, and maintaining the cutting knives for optimal performance.
Procedure for synchronizing the packer and ram movements for precise baling timing.
Detailed steps for adjusting needle length, position, and timing for proper tying.
Safety warnings and procedures for dealing with leaking hydraulic lines and fluids.
To Next Page
