E-10
3 TRANSPORT
After the machine has been adjusted to the transport position, it can
be transported by the tractor. Transport width amounts to 2,8 m.
Put the machine into the transport position as follows:
- The HIBISCUS 725 Classic model has a transport height of
3,95 m.
To reduce the transport height of the HIBISCUS Master cam rake
to 3,50 m, the 6 outer tine arms of each rotor can be demounted
and stored in the holder fitted to the back of the machine.
After this procedure, the protection bracket can be telescoped
inwards (fig. 6).
- Pull up the locking hooks for the hydraulic rams and retract the
rams completely.
- Check if the rams are secured by the locking hooks (fig. 7).
- Use all such lighting and warning signals as are mandatory by
law (or other regulations prescribed by the authorities).
- For transport on public roads: make sure that the front axle
weight is sufficient (fit front weights, if necessary) and that the
rear axle weight allowed as a maximum is not needed.
The machine is now ready for transport.
Never allow the PTO shaft to rotate when the machine is in the
transport position.
6
7
!
To Next Page