Need help?Do you have a question about the LELY Hibiscus 915 CD Vario and is the answer not in the manual?
General| Brand | LELY |
|---|---|
| Model | Hibiscus 915 CD Vario |
| Category | Farm Equipment |
| Language | English |
Details the warranty terms and conditions for the Lely Hibiscus, including exclusions and limitations.
Explains the function and installation of tine retainers to prevent tines from falling off.
Describes the optional system for lifting rotors independently, used with specific transport wheels.
Defines signal words (Danger, Warning, Caution) and their associated hazard levels and potential consequences.
Provides essential safety guidelines for operating and maintaining the Lely Hibiscus.
Details the meaning of various safety decals found on the Lely Hibiscus.
Illustrates the locations of safety decals on the Lely Hibiscus for easy identification.
Explains the hydraulic control panel functions and positions for operating the Hibiscus.
Step-by-step guide on connecting the Lely Hibiscus to a tractor.
Procedure for safely disconnecting the Lely Hibiscus from the tractor.
Instructions on how to move the Hibiscus from working position to transport position.
Guide on transforming the Hibiscus from transport/headland to working position.
Procedure for preparing and starting the raking operation with the Hibiscus.
Steps to move the Hibiscus from its working position to the headland position.
Instructions for setting the Hibiscus to its floating position for contour following.
Procedure for safely stopping the raking operation and preparing for transport.
Guidance on adjusting the working height of the Lely Hibiscus for optimal raking.
Instructions for adjusting the working width of the Lely Hibiscus.
Steps to adjust the height of the front and rear wheel assemblies.
Procedure for adjusting the cam track to optimize crop pick and release.
How to switch between simultaneous and independent rotor lifting modes.
Procedure for adjusting the headland position of the Lely Hibiscus.
Tasks required for maintenance after 10 working hours.
Tasks required for maintenance after 50 working hours.
Tasks required for maintenance after 100 working hours.
Tasks required for maintenance after 250 working hours.
Tasks required for maintenance every six years.
Routine maintenance tasks to perform after each operation.
Preparation tasks for the Hibiscus before long-term storage.
Tasks to perform after the Hibiscus has been in prolonged storage.
Procedure for cleaning the Lely Hibiscus, with precautions for sensitive parts.
Guidance on greasing all pivot points on the Hibiscus frame and rotors.
Instructions for greasing the PTO shaft components, including nipples and bearings.
Procedure for draining and refilling the gearbox oil with the correct type and quantity.
Procedure for correctly torquing the nuts of the tine arm carriage bolts.
Instructions on how to grease the cam track for smooth rotor operation.
Step-by-step guide for replacing broken or worn tines on the tine arms.
Procedure for replacing a damaged tine arm and its support.
Diagram illustrating the hydraulic system of the Lely Hibiscus.
Shows the recommended tyre pressures for the transport and rotor wheels.
Specifies standard torque loads for various bolt and nut sizes used on the Hibiscus.
Solutions for crop scattering behind the machine.
Troubleshooting steps when the PTO shaft overload clutch engages.
Adjustments to achieve an ideal swath shape.
Resolving issues with incorrect working width or swath shape.
Solutions for achieving a clean field after raking.
Action to take when a tine is broken due to excessive load.
Technical specifications for the Lely Hibiscus 915 CD model.
To Next Page