EasyManua.ls Logo

LENCO SCD-2000 BT - Using the Device on Batteries; Attaching the Shoulder Strap; First Use of the Remote Control

LENCO SCD-2000 BT
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Using the device on batteries
If the device is connected to the mains, first disconnect the power plug from the
outlet. Open the battery compartment (22) and install the batteries. Always remove
the batteries from the device when the device will not be used for long periods or
when the device is connected to the mains.
Attaching the shoulder strap
The shoulder strap allows you to bring the device anywhere you go. Attach the strap
to the attachment points (19) as indicated in the figure below.
First use of the remote control
Before the first use of the remote control, the plastic tab should be
pulled out of the remote.
Lenco recommends using A-brand batteries.
Bright ambient light may interfere with operation of the remote control.
Remove the batteries from the remote control when it is not being used for a
long time.

Related product manuals