LENCO SCD-2000 BT User Manual

23
Safety instructions
Explanation of symbols:
This symbol indicates that there are important operating maintenance
instructions in the user manual accompanying the device.
This symbol indicates that dangerous voltage is present within this device,
constituting a risk of electronic shock or personal injury.
CAREFULLY READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE USE.
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN THIS DEVICE
WARNING: DO REMOVE ANY SCREWS OR OTHER COMPONENTS OF
THE DEVICE TO PREVENT THE RISK OF ELECTRIC SHOCK.
 Install and use the device only as described in the user manual.
 This device must be used in combination with a power supply as specified in the
specification table. If you are not sure of the type of power supply used in your
home, consult your power company.
 Do not use loose or damaged cords and/or plugs.
 This device has a Class I construction. Devices with a Class I construction must
be connected to an earthed power outlet.
 This device has a Class II construction. Devices with a Class II construction can
be connected to an unearthed power outlet.
 The power outlet must be located close the device and must be easily accessible.
 Make sure that power outlets or extension cables are not over overloaded.
Overloading can cause short-circuits or fire.
 Always pull the plug when removing it from the power outlet.
 Do not pull the power cord. This may cause a short-circuit.
 If you notice smoke, an excessive build-up of heat or any other unexpected
phenomena, you should disconnect the plug from the power outlet immediately.
 Disconnect the plug from the power outlet during lightning storms.
 Disconnect the plug from the outlet when the device will not be used for a long
time.
 Do not step on the power cord and don’t pinch the power cord.
 Do not place heavy objects on the power cord or any other cables as this may
damage the cord or cables.
 Keep the device away from children! When they play with the power cord, they
can seriously injure themselves.
 Keep the power cable away from rodents and rabbits.
 Make sure all ventilation openings are clear at all times, do not cover or block
them.
 Leave 5 cm (2”) free space around the device.
 Always make sure the device is well ventilated.
 Keep the device away from heat sources such as radiators, heaters, stoves,
candles and other heat-generating products
 Avoid using the device near strong magnetic fields.

LENCO SCD-2000 BT Specifications

General

Brand	LENCO
Model	SCD-2000 BT
Category	Portable Stereo System
Language	English