LENCO SCD-24 User Manual

FM ST.FM MONO
ADJUSTING THE SOUND
LISTENING TO THE RADIO
POWER SUPPLY
1 . Set to RADIO
3 . Tune in to a station.
TUNING
4 . Adjust the sound.
GB 2
TO ADJUST THE VOLUME
2 . Select a MODE.
USING HOUSE CURRENT
Before use, check that the rated voltage of your unit matches
your local voltage.
Note: plug is used as the disconnect device.
the disconnect device shall remain readily operable.
USING BATTERIES
Disconnect the AC power cord from the AC inlet of the
unit. Battery power is cut automatically by the cord while
it is connected.
Insert 6 UM-2
( size C ) batteries.
battery door
When the volume decrease, or the sound distorts, replace
all of the batteries with new ones.
MODE
+
+
+
_
_
_
FUNCTION
RADIO
FOR PRIVATE LISTENING
Plug in headphones (ø3.5 mm stereo mini-plug) to the
PHONES jack.
When headphones are plugged in, the speakers are
automatically disconnected.
To AC socket
To AC outlet
VOLUME
MAX. MIN.
VOLUME
VOLUME
MAX. MIN.
VOLUME

LENCO SCD-24 Specifications

CD Section

channels	2 channels
S / N ratio	60 dB
sampling frequency	44.1 kHz
pick up wave length	790 nm

Radio Section

tuning ranges	FM 87.5 - 108 MHz
antennas	FM Rod antenna

General Specifications

output power	1 W + 1 W (RMS)
power consumption	13.5 W
power source AC	230V ~ 50Hz

Weight and Dimensions

dimensions	224(L) x 234(D) x 126(H)mm
weight	2.4 KGS