LENCO SCD-24 - Advanced Playback Features; Repeat Playback; Bass Boost; Programmed Playback

GB 4
REPEAT PLAYBACK
Note on CD-R/RW discs
- Because of non-standardized format denition/ production of CD-R/RW, playback quality and performance are not
guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
writing software, media ability, etc.
- Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
- It is recommended to record only audio les on CD-R/RW discs for easy reading.
BASS BOOST
To enjoy a BASS BOOST sound e󰀨ect,
press BBS button.
This function allows a single track or all tracks on a disc to be played repeatedly.
RE P EA T
PLAY
REP EAT
AL L
PLAY
TO CANCEL REPEAT PLAYBACK FUNCTION
Press the REPEAT button again until " REPEAT " or
" REPEAT ALL " disappears from the display.
TO REPEAT THE SAME TRACK
Press the REPEAT button once
during playback, the CD display
will indicate " REPEAT ".
TO REPEAT THE WHOLE DISC
Press the REPEAT button twice
until " REPEAT ALL" displays.
" PROGRAM "
PROGRAMMED PLAYBACK
Programmed playback enables tracks on a disc to be played
in the desired order. Up to 20 tracks can be programmed.
1. Press the " PROGRAM " button.
2. Press the " NEXT " and " BACK " buttons
to select the desired track number.
3. Press " PROGRAM " button again to memorize the
track.
4. Repeat steps 2 and 3 until all desired tracks are
programmed.
5. Press the " PLAY/PAUSE " button to start.
" PLAY " , " PROGRAM " & track number are
shown on the CD display.
6. Press " STOP " button to stop programmed
playback.
7. Press " PLAY/PAUSE " buttons to resume programmed
playback.
8. Open the CD door, turn o󰀨 the CD player or press
“ STOP ” button twice to clear the programmed memory.
Note : Programming can only be made when the player
is in stop mode.
PROGRAM PLAYBACK
CD display