To Next PageTo Next Page
Need help?Do you have a question about the Lennox CBX32MV-036 and is the answer not in the manual?
General| Brand | Lennox |
|---|---|
| Model | CBX32MV-036 |
| Category | Air Conditioner |
| Language | English |
Improper installation, adjustment, alteration, service or maintenance can cause injury, death, or property damage.
CFM ratings for various jumper settings and external static pressures in heat and cool modes.
Motor power consumption at various static pressures for heat and cool modes with '+' jumper setting.
Motor power consumption at various static pressures for heat and cool modes with '+' jumper setting.
Motor power consumption at various static pressures for heat and cool modes with '+' jumper setting.
Motor power consumption at various static pressures for heat and cool modes with '+' jumper setting.
Motor power consumption at various static pressures for heat and cool modes with '+' jumper setting.
Details kW input, Btuh input, blower amps, circuit ampacity, and overcurrent protection.
Warning about POE oils absorbing moisture and the importance of keeping the refrigerant system closed.
Warning about potential electric shock hazards due to foil-faced insulation and improper wiring.
Warning about running 24V Class II wiring only through specified openings.
Steps for making wiring connections, including line voltage, grounding, and low voltage wiring.
Table detailing terminal functions for communicating systems.
Guide for configuring unit operation via on-board links for various modes and accessories.
How to use the push button for mode selection, error code recall, and configuration.
Explanation of jumper settings for humidification, EvenHeat, blower CFM, and delay profiles.
Procedure to manually configure the AHC to detect electric heat sections.
Procedure to manually select the correct unit size code for the air handler.
Instructions for entering, viewing, and clearing error codes from the AHC.
Flowchart for checking the air handler control configuration, including unit size and heat mode.
Flowchart for selecting and detecting electric heat modes and stages.
Part 1 of the flowchart detailing EVENHEAT operation inputs and outputs.
Part 2 of the flowchart detailing EVENHEAT operation logic, including temperature adjustments.
Procedure to enter the error code recall mode by using the push button.
Instructions for clearing stored error codes from the air handler control.
Description of the electric heat operation sequence, including sequencers.
Description of the heat pump heating cycle, including supplemental heat.
Describes the heating sequence, including thermostat demand and control outputs.
Reference to Table 13 for the cooling sequence of operation.
Warning against using fuses larger than 3 amps to prevent damage and fire risk.
Wiring details for third-stage heat, including jumper removal.
Wiring details for first-stage heat for ECB40-20/25CB three phase units.
Wiring details for second-stage heat, including jumper removal.
Details on the discharge air sensor, its mounting, and temperature resistance chart.
Procedure to check for 240V power supply to the blower motor.
Procedure to apply a test signal to verify blower motor operation.
Procedure to test the Emerson motor control module for damage and resistance.
Check resistance between control module jack pins to detect faults.
Check resistance between motor terminals to detect faults.
Details on primary and secondary high temperature limit switches for electric heat.
Description of electric heat relays and their function in energizing heat stages.
Description of heating elements, their construction, and operation.
