Lennox CLIMATIC 200 User Manual

14
MODIFY UNIT PARAMETERS
ºC 0.1
ºC 0.1
ºC 0.1
--- 1
ºC 0.1
ºC 0.1
ºC 0.1
Num 1
ºC 1
--- 1
ºC 1
Num 1
--- 1
--- 1
--- 1
--- 1
--- 1
ºC 1
ºC 1
ºC 0.1
ºC 0.1
Num 1
Num 1
ºC 1
--- 1
Num 1
--- 1
ºC 0.1
ºC 0.1
Num 1
Num 1
ºC 1
--- 1
--- 1
--- 1
MIN MAX
2 CIRCUITS UNIT MODEL Climatic
®
400
DESCRIPTION
DEF UNIT VAR.
St4 configuration
Balancing of the circuits
Serial output configuration
Dynamic set point enable
Ext. temperature in cool Dynamic set point
Ext. temperature in heat Dynamic set point
Ext. temperature cool Dynamic set point differential
Family serial address
Heating thermal regulator hysteresis
Cooling thermal regulator hysteresis
Steps delta
0 25.5 1.5
0 25.5 1.5
0 25.5 1.5
Compressors activation sequence
010
Alarm relay polarity
Ext. temperature heat Dynamic set point differential
Device serial address
Internal antifrost heater set point in heat
MIN MAX
1 CIRCUIT UNIT MODEL Climatic
®
200
DESCRIPTION
DEF UNIT VAR.
Serial output configuration
Operation mode selection
Dynamic set point enable
Ext. temperature in cool Dynamic set point
Ext. temperature in heat Dynamic set point
Ext. temperature cool Dynamic set point differential
Ext. temperature heat Dynamic set point differential
Family serial address
Device serial address
Alarm output polarity
Internal antifrost heater set point in heat
Heating thermal regulator hysteresis
Cooling thermal regulator hysteresis
Steps delta
0 25.5 1.5
0 25.5 1.5
0 25.5 1.5
St4 configuration
03
127 35
010
14835
030
011
010
010
010
010
-127 127 35
-127
127 6
-50.0 80.0 -10.0
0140
0140
14835
010
020
010
-127
-12.7 12.7 -10.0
-12.7 12.7 6.0
0140
0140
127 6.0-127
-50.0 80.0 6.0
0: no probe / 3: outdoor temp.
0: selection by keyboard / 1: selection by digital input
0: no enable / 1: enable
0: open relay if the output is on
1: closed relay if the output is on
0: depending on operating hours
1: starting sequence
0: open relay if the output is on
1: closed relay if the output is on
0: saturation of the circuits
1: balanced circuits
0: no probe / 3: outdoor temperature
0: no enable / 1: enable
Operation mode selection
0: selection by keyboard / 1: selection by digital input
MAX: Maximum value for the parameter.
MIN: Minimum value for the parameter.
DEF: The default value, factory set.
UNIT: The units of measure used.
VAR.: Minimum variation allowed.
Compressors activation sequence
010
Water tank heater configuration:
011
0: Switched on by the controller
1: Switched automatically in defrost cycle
Water tank heater configuration:
011
0: Switched on by the controller
1: Switched automatically in defrost cycle

Lennox CLIMATIC 200 Specifications

General

Brand	Lennox
Model	CLIMATIC 200
Category	Network Router
Language	English