Need help?Do you have a question about the Lennox INNOV DM R Series and is the answer not in the manual?
General| Category | Heat Pump |
|---|---|
| Refrigerant | R-410A |
| Stages | Variable Speed |
| Series | DM R Series |
| Heating Capacity | 60, 000 BTU/h |
| Cooling Capacity | 60, 000 BTU/hr |
| Warranty | 5-Year Limited Warranty on covered components |
Describes the unit's construction, materials, and design features.
Defines operating conditions and storage requirements for DX and CW versions.
Details the components and function of the DX cooling circuit.
Explains the hydraulic section and 3-way valve for CW units.
Outlines essential rules and precautions for unit installation.
Covers procedures for unit inspection, lifting, and placement.
Introduces the principles of refrigerant phase behavior.
Details the process for achieving vacuum and charging the unit.
Explains how to remove refrigerant from a contaminated circuit.
Specifies the correct locations for refrigerant charging.
Covers general rules and checks for electrical connections.
Lists essential checks before starting the unit.
Explains general aspects of setting operating parameters.
Describes the function and settings of the high-pressure switch.
Describes the function and settings of the low-pressure switch.
Lists critical warnings for maintenance operations.
Details routine maintenance checks and their frequency.
Outlines necessary steps after cooling circuit repairs.
Details the procedure for testing the cooling circuit for leaks.
Explains methods for achieving a hard vacuum and drying the circuit.
Describes the process for recharging the system with R407C.
Covers regulations and best practices for environmental protection.
Guides the user through the initial unit start-up procedure.
Lists checks to perform while the unit is running.
Explains how to check refrigerant levels using the liquid level indicator.
To Next Page
