WIRING DIAGRAMS
PAGE 18
GAS CONTROL AND SAFETY SYSTEM WIRING DIAGRAM
CAUTION: Label all wiring prior to disconnection when servicing controls. Wiring errors can cause improper and dan-
gerous operation. Verify proper operation after servicing.
The gas control wiring diagram shown here should be used by service technicians for guidance when troubleshooting
problems with the pilot safety (millivolt) system or burner remote control system or when locating system components for
repair / replacement. Note: If replacement of any of the original wire is necessary, use 105°C thermoplastic wiring.
GAS CONTROL WIRING DIAGRAM
CIRCULATING BLOWER WIRING DIAGRAM
To Next Page
Loading...
