38
Appendix A. CRU instructions
C
Connect the AC power adapter and the cables to the computer.
To make sure that the DDR3 SDRAM is installed correctly, do as follows:
1
Shut down the computer.
2
Press the Novo button and then select BIOS Setup. The BIOS setup
utility screen opens. The System Memory item shows the total amount of
memory installed in your computer.
Note: If only one DDR3 SDRAM module is used on the computer you are servicing, it must be
installed in SLOT-1 ( ), but not in SLOT-2 ( ).
To Next Page
Loading...
