5. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
M.2 solid-state drive bracket
Prerequisite
Before you start, read Appendix A “Important safety information” on page 71 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See “Computer cover” on page 44.
2. Remove the front bezel. See “Front bezel” on page 45.
3. Remove the drive bay assembly. See “Drive bay assembly” on page 48.
4. Remove the M.2 solid-state drive and its heat sink (if any). See “M.2 solid-state drive and heat sink” on
page 52
5. Remove the M.2 solid-state drive bracket.
58 M70t and M80t User Guide
To Next Page