2. Remove the front bezel. See “Front bezel” on page 45.
3. Remove the drive bay assembly. See “Drive bay assembly” on page 48.
4. Disconnect the cable from the system board.
5. Remove the PCI-Express connector cable.
6. Install the PCI-Express connector cable.
7. Connect the new cable to the system board.
8. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
PCI-Express card
Prerequisite
Before you start, read Appendix A “Important safety information” on page 71 and print the following
instructions.
Chapter 7. CRU replacement 61
To Next Page