To Next Page

To Previous Page

Setting up your monitor

This section provides the following information:

● Assembling your monitor

● Connecting cables

● Turning on your monitor and computer

Note: Before setting up your monitor, ensure that you have read and understood the “Safety information” on page iii.

Assembling your monitor

To assemble your monitor, follow the five parts below one by one:

Part 1: Install the full-function monitor stand.

Part 2: Install the Tiny.

Part 3: Install the rear Wi-Fi antenna.

Part 4: Install the optical drive.

Part 5: Install the Kensington-style cable lock.

Note: The rear Wi-Fi antenna, the optical drive, and the Kensington-style cable lock are available only on some

models.

Part 1: Install the full-function monitor stand.

Note: The full-function monitor stand includes the stand that has been installed on the monitor and the base that

comes with the monitor.

1. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your monitor and gently lay it

down so that the screen is against the surface and the cover is facing up.

2. Insert the two metal studs into the corresponding holes in the stand. Then, tighten the screw that is

embedded in the base. Place the monitor in an upright position.

Part 2: Install the Tiny.

1. Gently hold the cable cover 1 and slide the latch to the right to open the cable cover. Then, push the decorative cover

2 upward to remove the decorative cover.

Note: Keep the decorative cover for future use.

ThinkCentre Tiny-in-One 23 User Guide

Lenovo ThinkCentre Tiny-in-One 23 User Manual

Questions and Answers: