To Next Page
R
Rachel WeberSep 1, 2025
What to do if Lenovo Server DVD is not working correctly?
- JJonathan FloydSep 1, 2025
If a Lenovo Server DVD is not working correctly, try cleaning the DVD. If problems persist, reseat the DVD drive.
What to do if Lenovo Server DVD is not working correctly?
If a Lenovo Server DVD is not working correctly, try cleaning the DVD. If problems persist, reseat the DVD drive.
How to fix Lenovo ThinkServer TD230 DVD drive tray that is not working?
If the Lenovo Server DVD drive tray is not working, ensure the server is turned on. If the tray still doesn't open, insert the end of a straightened paper clip into the manual tray-release opening. Reseat the DVD drive. If the problem persists, replace the DVD drive.
What to do if Lenovo Server does not turn off?
If the Lenovo Server is not turning off, determine whether you are using an Advanced Configuration and Power Interface (ACPI) or a non-ACPI operating system. If you are using a non-ACPI operating system: Press Ctrl+Alt+Delete. Turn off the server by pressing the power-control button for 5 seconds. Restart the server. If the server fails the POST and the power-control button does not work, disconnect the power cord for 20 seconds; then, reconnect the power cord and restart the server. If the problem remains or if you are using an ACPI-aware operating system, suspect the system board.
What to do if Lenovo Server DVD drive is not recognized?
If the Lenovo Server DVD drive is not recognized, ensure the SATA channel (primary or secondary) to which the DVD drive is attached is enabled in the Setup Utility program. Also, verify that all cables and jumpers are installed correctly, the signal cable and connector are not damaged, and the correct device driver is installed for the DVD drive. Reseat the DVD drive and its cables. If the problem persists, replace the DVD drive, its cables, or, as a last resort by a trained service technician, the system board.
How to fix a newly installed Lenovo Server optional device that does not work?
If a Lenovo optional device that was just installed does not work, ensure the device is designed for the server by checking the Lenovo website for supported options. Verify that you followed the installation instructions and that the device is correctly installed, without loosening any other devices or cables. Update the configuration information in the Setup Utility program. If issues persist, try reseating the newly installed device.
What to do if Lenovo ThinkServer TD230 mouse or pointing device does not work?
If the Lenovo Server mouse or pointing device is not working, ensure it's compatible with the server by checking the Lenovo website. Verify that the device cable is securely connected, the device drivers are correctly installed, and both the server and monitor are on. Also, confirm the mouse is enabled in the Setup Utility program. If using a USB device connected to a USB hub, disconnect it and connect it directly to the server. If problems persist, replace the mouse or pointing device or consult a trained service technician to replace the system board.
How to fix Lenovo ThinkServer TD230 keyboard when all or some keys do not work?
If all or some keys on the Lenovo Server keyboard do not work, ensure the keyboard cable is securely connected and that both the server and monitor are turned on. Verify the keyboard's compatibility with the server, referring to the Lenovo website. If using a USB keyboard connected to a USB hub, disconnect it and connect it directly to the server. If the issue persists, try replacing the keyboard or consult a trained service technician to replace the system board.
General| Form Factor | Tower |
|---|---|
| Memory | Up to 192GB DDR3 |
| RAID Support | RAID 0, 1, 10 |
| Networking | Integrated Gigabit Ethernet |
| Operating System Support | Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi |
