Lenovo ThinkSystem SN850 - Quick Start Manual

Lenovo ThinkSystem SN850 Compute Node
Type 7X15
Quick Start
PN: SP47A10202
Printed in China
In the box
 SN850 Compute Node
 Printed documentation
If any item is missing or damaged, contact your place of purchase.
Ensure that you retain your proof of purchase. They might be
required to receive warranty service.
First glance
Front view: Four 2.5-inch hot-swap HDD or SSD compute node
model
USB 3.0 connector
Drive status LED (yellow)
KVM connector
Power button/LED (green)
Drive activity LED (green)
Identification LED (blue)
Drive status LED (yellow)
Fault LED (yellow)
Drive activity LED (green)
USB management button
Setting up the system
1. Install the required compute node components.
2. Install the compute node into the chassis.
3. Make sure the chassis is connected to power.
4. Connect the management controller to the network.
5. Power on the compute node.
6. Configure the system.
For detailed information about installing hardware options and
configuring the system, see the following website:
http://thinksystem.lenovofiles.com/help/index.jsp
Technical specifications
Dimensions and weight
 Height: 55.5 mm (2.2 inches)
 Depth: 492.7 mm (19.4 inches)
 Width: 435.3 mm (17.1 inches)
 Weight:
 Minimum: 9.3 kg (20.6 lbs)
 Maximum: 12.3 kg (27.0 lbs)
Processor
Your compute node supports the following processor:
 Intel Xeon
®
processor scalable family
 Standard: Two processors
 Maximum: Four processors
Memory
 Slots: 48 DIMM connectors
 8 GB, 16 GB, and 32 GB RDIMMs
 64 GB LRDIMMs
Note: mixing of RDIMMs and LRDIMMs is not supported
Storage
 Supports up to four 2.5-inch hot-swap drive bays
 Supported drives:
 SAS/SATA hot-swap hard disk drives/solid-state drives
 NVMe solid-state drives
Networking
 Supports up to four I/O adapter slots for connecting to chassis
switch bays