Note: For SR150, SR250 and ST250, there are default settings for options on BMC settings page.
Table 15. BMC settings settings
Item
Options
Description
Power Restore Policy
• Always Off
• Restore
• Always On
Determine the mode of operation after loss of power.
[Always Off]: System remains off upon power restore.
[Restore]: System restores to the state it was before
power failed. [Always On]: System turns on upon power
restore. Allow a few minutes for the changes to take
effect.
Note: This option is configuration dependent, and this
item could not use Setup load default to back to default
value.
Power Restore Random Delay
• Enabled
• Disabled
Provide a random delay between 1 and 15 seconds for
Power On. If system state is on before power fails, the
system will delay Power On once power is restored.
Notes:
• This item is configuration dependent, and it cannot
restore to default value by using the "load default"
option in Setup.
• When the Power Restore Policy is [Always Off], the
item is not displayed.
Chapter 3. System configuration and boot management 49
To Next Page
Loading...
