Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFPU4045G Physical Presence is not asserted, abort TPM Firmware upgrade. Warning
FQXSFPU4050G
Failed to update TPM Firmware. Warning
FQXSFPU4051G Undefined TPM_TCM_POLICY found
Warning
FQXSFPU4052G TPM_TCM_POLICY is not locked
Warning
FQXSFPU4053G System TPM_TCM_POLICY does not match the planar.
Warning
FQXSFPU4054G TPM/TCM card logical binding has failed.
Warning
FQXSFPW0001L CMOS has been cleared. Warning
FQXSFSM0002N Boot Permission denied by Management Module: System Halted.
Warning
FQXSFSM0003N Timed Out waiting on boot permission from Management Module:
System Halted.
Warning
FQXSFSM0004M An XCC communication failure has occurred.
Warning
FQXSFSR0001M [arg1] GPT corruption detected, DiskGUID: [arg2] Warning
FQXSFSR0003G The number of boot attempts has been exceeded. No bootable
device found.
Warning
FQXSFTR0001L
An invalid date and time have been detected. Warning
FQXSFDD0004M DRIVER HEALTH PROTOCOL: Reports 'System Shutdown' Required
Controller.
Error
FQXSFIO0010M An Uncorrectable PCIe Error has Occurred at Bus [arg1] Device [arg2]
Function [arg3]. The Vendor ID for the device is [arg4] and the Device
ID is [arg5]. The Physical slot number is [arg6].
Error
FQXSFIO0011M A PCIe parity error has occurred on Bus [arg1] Device [arg2] Function
[arg3]. The Vendor ID for the device is [arg4] and the Device ID is
[arg5]. The Physical slot number is [arg6].
Error
FQXSFIO0012M A PCIe system error has occurred on Bus [arg1] Device [arg2]
Function [arg3]. The Vendor ID for the device is [arg4] and the Device
ID is [arg5]. The Physical slot number is [arg6].
Error
FQXSFMA0001M DIMM [arg1] has been disabled due to an error detected during POST.
[arg2]
Error
FQXSFMA0002M An uncorrectable memory error has been detected on DIMM [arg1] at
address [arg2]. [arg3]
Error
FQXSFMA0003K A memory mismatch has been detected. Please verify that the
memory configuration is valid. [arg1]
Error
FQXSFMA0004N No system memory has been detected. [arg1] Error
FQXSFMA0005N Memory is present within the system but could not be configured.
Please verify that the memory configuration is valid. [arg1]
Error
FQXSFMA0008M DIMM [arg1] has failed the POST memory test. [arg2]
Error
FQXSFMA0027K Invalid memory configuration (Unsupported DIMM Population)
detected. Please verify memory configuration is valid.[arg1]
Error
FQXSFMA0029L The [arg1] PFA Threshold limit has been exceeded on DIMM [arg2].
[arg3]
Error
Chapter 3. UEFI events 127
To Next Page
Loading...
