The following table lists supported internal storage configurations with the SAS/SATA and AnyBay backplanes.
Table 17. Internal storage configurations
Drive bay configuration
Backplane and cable
type and quantity
Storage controller quantity and type*
3.5" chassis (Feature code B403)
4x 3.5-in. SATA simple-swap 1 0 0 0 0 0 0 0 0 1x Onboard AHCI / RSTe (4)
0 1 0 0 0 0 0 0 0 1x RAID 530/730/930-8i/930-16i (4)
1x 430-8i/16i HBA (4)
4x 3.5-in. SAS/SATA hot-swap 0 0 1 0 0 1 0 0 0 1x Onboard AHCI / RSTe (4)
0 0 1 0 0 0 0 1 0 1x RAID 530/730/930-8i/930-16i (4)
1x 430-8i/16i HBA (4)
2.5" chassis (Feature code B404)
8x 2.5-in. SAS/SATA hot-swap 0 0 0 1 0 0 1 0 0 1x Onboard AHCI / RSTe (8)
0 0 0 1 0 0 0 2 0 1x RAID 530/730/930-8i/930-16i (8)
1x 430-8i/16i HBA (8)
10x 2.5-in. SAS/SATA hot-swap 0 0 0 0 1 0 0 3 0 1x RAID 930-16i (10)
1x 430-16i HBA (10)
8x 2.5-in. SAS/SATA +
2x 2.5-in. NVMe hot-swap
0 0 0 0 1 0 0 2 2 1x RAID 530/730/930-8i/930-16i (8) + 1x 1610-4P (2)
1x 430-8i/16i HBA (8) + 1x 1610-4P (2)
2x 2.5-in. NVMe hot-swap 0 0 0 0 1 0 0 0 2 1x 1610-4P (2)
* The number in brackets (x) specifies the quantity of drive bays connected to each of the controllers.
4x 3.5" SS BP SW (B407)
4x 3.5" SS BP HW (B408)
4x 3.5" HS BP (B412)
8x 2.5" HS BP (B413)
10x 2.5" HS BP (B414)
4x3.5" HS x4 Cable SW (B405)
8x2.5" HS 2x4 Cable SW (B406)
3.5"/2.5" HS x4 Cable HW (B415)
10x 2.5" HS NVMe Cable (B416)
To Next Page
Loading...
