Location of the external diagnostics handset
Location
Description
The external diagnostics handset is connected to the
server with an external cable.
1 External diagnostics handset
2 Magnetic bottom
With this component, the diagnostics handset can be
attached to the top or side of the rack with hands spared
for service tasks.
3 External diagnostics connector
This connector is located on the front of the server and is
used to connect an external diagnostics handset.
Note: Pay attention to the following steps when unplugging the external diagnostics handset:
Step 1. Press the plastic clip on the plug in the shown direction.
Step 2. Gently pull out the cable from the connector while keeping the clip pressed down.
Diagnostics panel overview
The diagnostics device consists of an LCD display and 5 navigation buttons.
28
ThinkSystem SR665 V3 System Configuration Guide
To Next Page
Loading...
