Service Label and QR code
In addition, the system Service Label located on the surface of the front top cover, provides a quick response
(QR) code for mobile access to service information. You can scan the QR code with a mobile device using a
QR code reader application and get quick access to the Service Information web page. The Service
Information web page provides additional information for parts installation and replacement videos, and error
codes for server support.
Figure 30. Service Label and QR code
Server setup checklist
Use the server setup checklist to ensure that you have performed all tasks that are required to set up your
server.
The server setup procedure varies depending on the configuration of the server when it was delivered. In
some cases, the server is fully configured and you just need to connect the server to the network and an AC
power source, and then you can power on the server. In other cases, the server needs to have hardware
options installed, requires hardware and firmware configuration, and requires an operating system to be
installed.
The following steps describe the general procedure for setting up a server.
Setup the server hardware
Complete the following procedures to setup the server hardware.
1. Unpack the server package. See
“Server package contents” on page 59.
Chapter 4. Unboxing and setup 61
To Next Page
Loading...
