Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFMA0041K Near Memory/Far Memory ratio (1:[arg1].[arg2]) for Intel Optane
PMEM configuration is not in recommended range (1:[arg3] - 1:[arg4]).
Warning
FQXSFMA0047M SPD CRC checking failed on DIMM [arg1]. [arg2]
Warning
FQXSFMA0076M DIMM [arg1] is not supported, DIMM identifier is [arg2].
Warning
FQXSFPU0022G The TPM configuration is not locked. Warning
FQXSFPU0023G Secure Boot Image Verification Failure Warning.
Warning
FQXSFPU0033G Processor has been disabled. Warning
FQXSFPU0062F System uncorrected recoverable error happened in Processor [arg1]
Core [arg2] MC bank [arg3] with MC Status [arg4], MC Address [arg5],
and MC Misc [arg6].
Warning
FQXSFPU4033F TPM Firmware recovery is in progress. Please DO NOT power off or
reset system.
Warning
FQXSFPU4035M TPM Firmware recovery failed. TPM chip may be damaged. Warning
FQXSFPU4040M TPM selftest has failed. Warning
FQXSFPU4043G TPM Firmware update aborted. System is rebooting...
Warning
FQXSFPU4050G
Failed to update TPM Firmware. Warning
FQXSFPU4051G Undefined TPM_POLICY found
Warning
FQXSFPU4052G TPM_POLICY is not locked Warning
FQXSFPU4053G System TPM_POLICY does not match the planar. Warning
FQXSFPU4054G TPM card logical binding has failed. Warning
FQXSFPW0001L CMOS has been cleared. Warning
FQXSFSM0002N Boot Permission denied by Management Module: System Halted. Warning
FQXSFSM0003N Timed Out waiting on boot permission from Management Module:
System Halted.
Warning
FQXSFSM0004M An XCC communication failure has occurred.
Warning
FQXSFSR0001M [arg1] GPT corruption detected, DiskGUID: [arg2]
Warning
FQXSFSR0003G The number of boot attempts has been exceeded. No bootable
device found.
Warning
FQXSFTR0001L
An invalid date and time have been detected. Warning
FQXSFDD0004M DRIVER HEALTH PROTOCOL: Reports 'System Shutdown' Required
Controller.
Error
FQXSFDD0012K SATA Hard Drive Error: [arg1]. Error
FQXSFIO0005M An intra-board UPI failure has been detected on the link between
processor [arg1] port [arg2] and processor [arg3] port [arg4].
Error
FQXSFIO0006M An inter-board UPI failure has been detected on the link between
processor [arg1] port [arg2] and processor [arg3] port [arg4].
Error
Chapter 3. UEFI events 145
To Next Page
Loading...
