For tower form factor models, the foot stands help the server stand steadily.
Server models with sixteen 3.5-inch drive bays
Figure 3. Front view of server models with sixteen 3.5-inch drive bays
Table 4. Components on server models with sixteen 3.5-inch drive bays
1 Front I/O module
5 3.5-inch drive bays 8-11
2 Drive activity LED (green)
6 3.5-inch drive bays 4-7
3 Drive status LED (yellow)
7 3.5-inch drive bays 0-3
4 3.5-inch drive bays 12-15 8 Foot stands
1 Front I/O module
For information about the front operator panel LEDs on this front I/O module, see
“Front operator panel
LEDs” on page 32
.
2 3 Drive activity LED (green) and Drive status LED (yellow)
For information about Drive LEDs, see
“Drive LEDs” on page 31.
4 5 6 7 3.5-inch drive bays
The drive bays are used to install 3.5-inch drives. When you install drives, follow the order of the drive bay
numbers. The EMI integrity and cooling of the server are protected by having all drive bays occupied. The
vacant drive bays must be occupied by drive bay fillers or drive fillers.
Note: For 3.5-inch drive bay models that support NVMe drives, up to sixteen NVMe drives can be installed in
bays 0-3, 4-7, 8-11, and 12-15.
8 Foot stands
For tower form factor models, the foot stands help the server stand steadily.
Chapter 2. Server components 21
To Next Page
Loading...
