Lenovo ThinkSystem ST650 V3 - Configure the firmware

options installed, requires hardware and firmware configuration, and requires an operating system to be
installed.
The following steps describe the general procedure for setting up a server.
Setup the server hardware
Complete the following procedures to setup the server hardware.
1. Unpack the server package. See
“Server package contents” on page 49.
2. Install any required hardware or server options. See the related topics in “Hardware replacement
procedures” in User Guide or Hardware Maintenance Guide.
3. If necessary, install the rail to a standard rack cabinet. Follow the instruction in Rail Installation Guide
that comes with the rail installation kit.
4. If necessary, install the server into a standard rack cabinet. See “Install the server to rack” in User Guide
or Hardware Maintenance Guide.
5. Connect all external cables to the server. See
Chapter 2 “Server components” on page 19 for
connectors locations.
Typically, you will need to connect the following cables:
• Connect server to the power source
• Connect server to the data network
• Connect the server to the storage device
• Connect the server to the management network
6. Power on the server.
Power button location and power LED are specified in:
•
Chapter 2 “Server components” on page 19
• “Troubleshooting by system LEDs and diagnostics display” on page 31
The server can be turned on (power LED on) in any of the following ways:
• Press the power button.
• The server can restart automatically after a power interruption.
• The server can respond to remote power-on requests sent to the Lenovo XClarity Controller.
Note: You can access the management processor interface to configure the system without powering
on the server. Whenever the server is connected to power, the management processor interface is
available. For details about accessing the management server processor, see “Opening and Using the
XClarity Controller Web Interface” section in the XCC documentation compatible with your server at
https://sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html.
7. Validate the server. Make sure that the power LED, Ethernet connector LED, and network LED are lit with
green light, which means the server hardware was set up successfully.
See “System LEDs and diagnostics display” on page 31 for more information on the LED indications.
Configure the system
Complete the following procedures to configure the system. For detailed instructions. refer to
Chapter 5
“System configuration” on page 55
.
1. Set the network connection for theLenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
52
ThinkSystem ST650 V3 System Configuration Guide