45
© Copyright Lenovo 2007
Chapter 5. Upgrading and Replacing Devices
Replacing the Battery
1. Turn off the computer, or enter hibernation mode. Then disconnect the
AC adapter and all cables from the computer.
Note: If you are using an ExpressCard, the computer might not be able
to enter hibernation mode. If this happens, turn off the
computer.
2. Close the computer display, and turn the computer over.
3. Unlock the battery latch a by sliding it to the unlocked position.
4. Unlock the battery latch b by sliding it to the unlocked position. While
holding the latch b in the unlocked position, lift the battery c by
pulling from the groove d.
Read Safety and Warranty Guide before replacing the battery.
Important
a
b
c
d
Lenovo EVEREST UG.book Page 45 Friday, August 17, 2007 5:40 PM
To Next Page
Loading...
