Lenoxx FD1550 - Page 5

INSTALLBATTERIESINTOTHECONTROLLER:

1. Removethescrewonthebatterycoverandremovethebatterycover.
2. Add4xAAsizebatteries(notincluded)accordingtothecorrectpolarity.
3. Addthebatterycoverandscrewdownthescrewtoholditinplace.
INSTALLATIONOFTHE
PHONEHOLDER:

InstallationofthephoneholderRemovalofthephoneholder
Pushinthephoneholderalongtheslidingchuteontherearofthecontroller.Thephoneholderis
correctlyinplacewhenyouhearaslight‘click’.Lockinthescrewwithascrew driver. 
Toremovethe
phoneholder,removethescrewwithascrewdriver.
Presstheroundbuttonlocatedjustundertheslidingchuteontherearofthecontroller.While
pressingthebuttondown,pullthephoneholderupwardsoutoftheslidingchute.

Thepositionofthephoneholdercanbeadjusted
throughthreeparts
ofthephoneholder.



