Lenoxx FD1550 - Page 6

INSTALLATIONOFTHEPROTECTIVERINGS:
Removetheprotectiveringsandcorrespondingscrews
fromtheaccessoriespackage.
Alignthescrewpositionontheprotectiveringonto the
‘arm’ofthedrone.
Cliptheprotectiveringintothe‘arm’ofthedrone.
Useananchorscrewandthescrewdrivertoscrewthe
protective
ringinplace.
Toremovetheprotectiveringfromthedrone,usethescrewdrivertoundothescrew,thenholdthe
protectiveringclosetothe‘arm’ofthedrone.Pulltheprotectiveringoffthe‘arm’ofthedroneina
gentleupwardsmotion.
CHARGINGOFTHELITHIUMBATTERY:
Thebatterypackmayneedchargingbeforeflying.
Afullchargeofthebatterycantake150–180minutes.
Theflighttimeonafullychargedbatteryisupto15minutes.
Tochargethebattery:
Removethebatteryfromthedronebypushingdownonthereleasepointson
thebattery.
Connectthechargeleadtothechargingportonthebattery.
ConnecttheUSBendtoaUSBchargingpoint.
Whilethebatteryischarging,thelightonthebatterywillshowredlightsindicatingthechargelevel
ofthebattery.
Whenthebatteryhascomplete d charging,the
3redlightsonthebatterywillremainon(still).
Whenchargingiscomplete,disconnectthechargeleadfromthebattery.
Putthebatteryintothedrone.
*Ifthedronewillnotbeusedforalongtime,pleasemaintain50%ofchargeinthebattery,soasto
lengthenthe
servicelifeofthebattery.Tomaintain50%charge,itonlyneedstobechargedfor90
minutes.