Information LH100 V3 71
DIGITAL plus
15.2 Error messages on the display
The LH100 will display an error message on the display it you
have done something that was not allowed at this time. To clear
the display and either back up or resume operation, just press the
or key
Here is the list of possible error messages
Error happens
during
Explanation
ERR 01 PROG When programming or reading a decoder, a power overload
(short circuit) was detected. The decoder may not be correctly
connected or may be defective.
ERR 02 PROG When programming or reading a decoder, no decoder
acknowledgement was detected. That could mean that the
decoder is not correctly connected to the programming output
on command station LZ100 (for example the digital locomotive
may not be properly placed on the programming track) or the
decoder is not functioning properly.
ERR 24 DH/MU The locomotive was not selected or no command to the
locomotive was sent prior to setting up the MU/double header.
ERR 25 DH/MU One of the locomotives of the MU/double header is being
operated on another Handheld.
ERR 26 DH/MU One of the locomotives is already part of another MU/double
header.
ERR 27 DH/MU One of the two locomotives was not at throttle position 0.
Locomotives must be stopped before you can combine them
into a consist.
ERR 30 Command
station
stack
It is not possible to erase locomotive from command station
stack.
ERR 31 Command
station
stack
The Command station stack is full. You must remove a
locomotive address before you can add another address.
To Next Page
