Information LH100 V3 3
DIGITAL plus
1 Important information — Please read first!
Your LH100 hand held controller is a component of the
Digital plus by Lenz
®
system and was subjected to intense testing
before shipping. Lenz Elektronik GmbH guarantees problem free
operation when you follow these directions:
Depending on which command station (and which software version)
you operate your LH100 on, certain functions are not or are only
partially available. This manual contains all the possible LH100
capabilities present when used with an LZ100 V3. If you are using a
different command control system, the LH100 capabilities may be
reduced by the capabilities provided by that system. For details check
out the system manual of the system you desire to use your LH100 on.
The LH100 must only be used with systems that have been branded to
support XpressNET or the older X-Bus protocols. A branded system
will display the XpressNET logo. Any other use than the one described
in this operation manual is not allowed and will lead to voiding of the
warranty.
Even when other devices (including ones from other manufacturers)
have the same connectors, you may not operate the LH100 with these
devices unless they display the XpressNET logo. Other systems may
use the same connectors but have different internal wiring that can
harm the LH100.
Do not expose the LH100 to moisture or extended direct sunlight.
FF If you have problems,
please first check this operation manual to see if you may
have missed a direction for use. The table of contents and
especially the section “Troubleshooting” will help you here.
1 3 8
LH100 Configured with
German Display
LH100 Configured with
English Display
If you need to change the display language please refer to
section 14.2.2 starting on page 63.
To Next Page
