10 Information SET-02
3.8 Controlling turnouts
Although the possibilities opened through SET-02 features are many
and varied, SET-02 does have some limits. The LH200 contained in
SET-02 is not able to control turnouts or switch magnetic articles on
and off. This capability was omitted to keep the LH200 easy for a
train operator. Should you desire to be able to control turnouts or
other similar devices this can be achieved easily by connecting an
LH100 or a similar X-Bus device which contains these capabilities.
More detailed information on this can be found in the section
"Special information on operating X-Bus devices " which starts on
page 41.
3.9 Expanding beyond SET-02
SET-02 is part of our overall DIGITAL plus family. Should you ever
need more capabilities, (such as the ability to use more handhelds
or layout feedback) you can upgrade a SET-02 to our full
professional series by installing an LZ100 command station. When
the LZ100 is installed it becomes the command station and the
LH200, used as a command station in SET-02, becomes an
additional handheld for use anywhere on the installed X-Bus.
Gathering feedback about the switching of turnouts or the
occupation of track sections is possible only when SET-02 is
upgraded with the command station LZ100 . You will find more
information on this in the section Expanding beyond the capabilities
of SET-02 using an LZ100 Command Station" which starts on page
43.
4 Overview of the LH200 Operational Controls
In this section you will learn about:
- the information that is displayed in the LH200 LED display
- how to use the LH200 knob based Engineer's Throttle
- how to use the direction switch
- what the LH200 keys are used for
4.1 The LED display
LH200 has a luminescent, 4-digit LED-display. Each digit is able to
display the numbers 0 to 9.
In this operating manual the display is presented as follows:
To Next Page
Loading...