Information SET-02 9
DIGITAL plus
Programming on the programming track
A programming track is an section of track that is completely
electrically isolated from the remainder of your layout. One decoder
at a time can be placed on this isolated track for setting the various
decoder configurations. For advanced decoders, only the locomotive
address needs to be set using this programming mode. You will find
information on this procedure in the section "Programming on the
programming track" which starts on page 35.
Programming while your locomotive is on your layout
For advanced decoders that support this feature, you can program
all the optional features of a locomotive decoder (except its address)
while the locomotive is on your DCC layout. For example, move your
locomotive to the front of a heavy freight-train and then adjust the
acceleration and breaking rate to suit the train! You will find more
detailed information in the section "Programming on the main –
POM" which starts on page 21.
3.6 Power Station capabilities
The power station, LV200, which is part of SET-02 can provide a
maximum current output of 10 amps. Depending on the demand for
current of the locomotives in operation, this is sufficient for 8 –12
large scale locomotives. If the capacity of a single LV200 power
station is not sufficient, you can add additional power stations. You
will find information on such expansion in the section "More power
through more power stations", which starts on page 42.
3.7 Expanding your system
You can connect up to 5 additional devices, such as additional
handhelds, to your SET-02. Which of the devices you decide to
choose from the Digital plus family is entirely up to you.
Examples:
Additional LH200s may be added for a more engineers.
Additional LH100 keypad based dispatchers throttles may be
added for operating locomotives or for switching turnouts or
signals.
A tower cab LW100 may be added to switch not only individual
turnout but entire turnout systems.
The computer interface, LI100, may be added to control your
model railway from your PC.
More detailed information on this can be found in the section
"Adding an X-Bus to allow additional input Devices" which starts on
page 40.
To Next Page
Loading...
Need help?
General