Lenze 7812 - 7 Modification of Factory-Set Paraineters; Keyboard Operation

ET46/fa checked: 19.04.89 MB 33.0831 GB page: 13
7. Moditication ot the factory—set parameters
7.1 Keyboaxd operation
In order to change the parameters, open the switch S2 (which
activates braking) so that the display is flashing. By pressing
the „PRG“ key, the inverter is switched to the program mode. The
tunction code is displayed in the twa lett segments. By pressing
the „SHIFT“ key the desired tunction code can be selected. After
this, the data code can be chosen using the keys marked ~1 1=11 ~
and „ 7 „. lt this value is the desired new parameter, press the
„SET“ key.
lt you want to change other paraxneters, select the next
tunction code using the „SHIFT“ key. lt all parameters are
modified as deslred, the inverter is swltched to the normal
operating mode by pressing again the „PRG“ key. After re-closing
the swltch S2, the inverter operates with the new set parameters.
~FTFi7T71
~9I§LLILI
1~z~
— SHIFT — — SET —