Lenze 8609 E.6x.6 Series - Page 124

122

E
Electrical installation, 20
EMC directive
Purpose, 11
Energy sharing, 34
Extended code set, 99
External fault, 118
F
Factory setting
Monitor outputs, 89
Fault
Reset, 117
Fault indication
TRIP reset, 79
TRIP set, 79
Fault indication (TRIP), 88
Fault reset, LECOM interfaces, 117
Features
Inverters, 7
Feedback
analog, 73
digital, 73
Feedback = set-value, 88
Feedback display, 77
Feedback gain, 75
Field frequency
maximum, 71
minimum, 71
Fixed set-values (JOG frequencies), 80
Flying restart circuit, 89; 95
Accuracy, 96
free space, 19
Freely assignable input, 32
Frequency pilot control
Influence PI controller, 74
G
Gain
Adjustment, 67
Gases
aggressive, 19
Grounding
Control electronic, network of drives,
35
Control electronics, 35
Control electronics, single drives, 35
H
High resolution data
Set-value 1, 112
Total set-value, 112
I
I-t monitoring, 97
I0control, 70
I0 set-value, 70
V/f rated frequency, 70
Incremental encoder, 73
Inputs
Actual value, 29
analog, 29
digital, 30; 32
Digital frequency/incremental encoder,
27
digital, Changing the functions, 78
digital, factory setting, 78
digital, freely assignable, 78
Set-value 1, 29
Set-value 2, 29
Installation
electrical, 20
mechanical, 19
installation altitude, 8
Integral action component (I-component),
77
Interbus-S, 110; 111
Inverter overload, 118
J
JOG frequencies
Enabling, Keypad or LECOM, 81
Enabling, terminal control, 81
Programming, 80
JOG frequencies (Fixed set-values), 80
K
Keypad
Key functions, 53
L
LECOM
Attribute table, 113
LECOM codes, 110
LECOM interface (RS232/485), 27
LECOM-A/B, 51; 109
Level converter 2101IP, 51
LECOM-LI, 51
LECOM1, 109
Baud rate, 111
Code bank, 111
LECOM2, 110
LECOMA/B
Level converter 2101IP, 109
Load change damping, 96
Low-Voltage Directive
Objective, 11