Mechanical installation 5
EDK82ZBC DE/EN/FR 3.1
45
H1_MechINS-install_de
5 Mechanical installation
Note!
The keypad is supplied already attached to the hand terminal by means of a
screw-type connection on the rear of the keypad (only in the case of E82ZBB) or
is to be attached to a hand terminal that has already been connected (hand
terminal as an accessory). For stationary attachment of the keypad, e.g. in a
control cabinet wall, you need the installation set E82ZBHT (see associated
documentation).
To Next Page
Loading...
