6 Operation
Change and save parameters
EDK82ZBC DE/EN/FR 3.1
54
Parameter ändern u speichern----(DUMMYSEITEVOR)---
Change and save parameters
Note!
ƒ The user menu is active after mains switching. Change to the all menu to address all codes.
ƒ With the keypad you can only change parameter values in the parameter sets.
ƒ A parameter set can only be activated for operation by means of digital signals (configuration via
C0410)!
ƒ In the function, the keypad shows the parameter set which is currently active during operation.
Step
Key sequence Result Action
1. Connect keypad
xx.xx Hz
The function is active. The first code in the user menu is
displayed (C0517/1, Lenze setting: C0050 = output frequency).
2.
If required, change to
the ”ALL” menu
o
Change to function bar 2
3.
4.
all
Select ”ALL” menu (list of all codes)
5.
n
Confirm selection and change to function bar 1
6.
Select parameter set
for change
o
Change to function bar 2
7.
8.
1 ... 4
Select parameter set to be changed
9.
n
Confirm selection and change to function bar 1
10. Inhibit controller
Only necessary if you change C0002, C0148, C0174, and/or
C0469
11.
Set parameters
12.
XXXX
Select code
To Next Page
Loading...
